Cat C32 ACERT Generator Set (EPA Tier 3)

Cat C32 ACERT Generator Set (EPA Tier 3)

360° Exterior View

C32 ACERT generator sets incorporate a separate circuit aftercooling system (SCAC) for all configurations. The primary advantage of the SCAC systsem is reduced aftercooler corrosion since no sea ...
Print SHARE

Generator Set Specifications

Minimum Rating
730 ekW (913 kVA)
Maximum Rating
940 ekW (1175 kVA)
Frequency
60hz
Speed
1800 rpm
Emissions/Fuel Strategy
EPA Tier III

Engine Specifications

Aspiration
Turbocharged and aftercooled
Bore
5.7in
Stroke
6.38in
Displacement
1959in³
Governor Type
Electronic
Fuel System
MEUI
Engine Model
Vee-12, 4-stroke-Cycle-Diesel

Generator Specifications

Excitation
Permanent magnet
Number of Poles
4
Number of Bearings
2 roller bearings
Number of Leads
6
Insulation
Class H
IP Rating
23
Voltage Regulator
CDVR

Generator Set Dimensions

Width
60.2in
Height
65.6in
Weight - Estimated
15721lb
Length
162.8 in/4271 mm (minimum), 175.3 in/4452 mm (maximum)

Emissions

U.S. EPA Tier 3 compliant

Worldwide Support

Extensive service network of dealers; Unparalleled service from authorized marine dealers

Durability

Proven engine operating history; Performance iron with thousands of hours of validation testing for quality and durability

Reliability

60 months standard warranty

Cooling System

Heat Exchanger or Keel Cooling; Heat exchanger configurations: optional front mounted sea water pump

Aftercooling System

Separate circuit aftercooling system (SCAC): no seawater circulating through the aftercooler

Standard Equipment:

Optional Equipment:

    Alarm And Protection
    • Remote panels
    • MCS Controller
    • Power analyzer module
    • Oil level, exhaust temperature, air starting pressure, heat exchanger pressure sensors
    Exhaust System
    • Dry Elbows
    • Flexible Fitting
    • Flange
    • Muffler
    • Muffler Spark Arresting
    • Rain Cap
    • Water-cooled exhaust manifold & turbocharger
    • 4 Bolt 130 mm (5.12 in) diameter flanged outlet
    Charging System
    • Battery Chargers, Charging Alternators
    Control System
    • If an EMCP panel or MGCP option is not chosen as optional equipment, then start/stop controls must be provided by the customer
    • Electronic diagnostics and fault logging
    • Engine Protection Mode for extended ambient conditions
    • Electronic fuel/air ratio control
    • Load Sharing Attachment
    Fuel System
    • Water Separator
    • Duplex Fuel Filters, Spin-on, RH service
    • Fuel connections size: Supply JIC 37 Deg -10 (7/8-14), Return JIC 37 Deg -8 (3/4-16)
    • Plate-type fuel cooler installed behind Aftercooler Shunt Tank
    • Fuel transfer pump, gear driven
    • Manual fuel priming pump
    Protection System
    • Fuel and Oil Shielding
    Starting System
    • Electric Starting Motors - Single 24 Volt
    • Air Starting Motor
    • Dual Starting Motors (Electric and Air)
    • Air Start Accessories
    • Starting Aids - JW Heaters
    • Battery Sets - 24 Volt - Dry