DG200 GC (3 phase)

DG200-2 (3 phase)

THE RUNDOWN

Engine
  • Four-stroke-cycle gas engine combines consistent performance and excellent fuel economy with minimum weight
Generator
  • Matched to the performance and output characteristics of Cat engines
  • Industry leading mechanical and electrical design
  • Industry leading motor starting capabilities
  • High Efficiency
EMCP Control Panel
  • User-friendly interface and navigation
  • Scalable system to meet a wide range of installation requirement
  • Expansion modules and site-specific programming for specific customer requirements
Design Criteria
  • The generator set facilitates compliance with NFPA 110 and meets ISO 8528-5 requirements for transient response
  • Cooling system designed to operate in 50˚C/122˚F ambient temperatures with an air flow restriction of 0.5 in. water
UL 2200 / CSA - Optional
  • UL 2200 Listed packages
  • CSA Certified
  • Certain restrictions may apply
  • Consult with your Cat® Dealer
Worldwide Product Support
  • Cat dealers have over 1,800 dealer branch stores operating in 200 countries
  • Your local Cat dealer provides extensive post-sale support, including maintenance and repair agreements
Generator Set Specifications
Frequency60 Hz
Natural Gas Rating200 eKW
Emissions/Fuel StrategyU.S. EPA Certified for Non-Emergency Application
Displacement864.71in
Fuel TypeNatural Gas
Speed1800 rpm
Engine Specifications
Engine Model14.2 L, Inline 6, 4 Cycle, Spark - Ignited
Fuel SystemCarburetor, Down Draft
AspirationTurbocharged-Aftercooled
Governor TypeElectronic
Compression Ratio9.5:1
Bore5.31in
Stroke6.5in
Generator Set Dimensions
Length127.95in
Width52.93in
Height67.37in
Weight5756lb
Standard Equipment

Cooling

  • Closed coolant recovery system
  • Factory-installed radiator
  • 50/50 Ethylene glycol antifreeze
  • Radiator and cooling fan complete with protective guards
  • Standard ambient temperatures up to 50°C (122°F)

Air Inlet

  • Single element air filter

Fuel

  • Primary and secondary fuel shut-off
  • Low fuel pressure switch
  • Fuel pressure test po
  • Natural Gas or LP Vapor
  • NPT connection
  • Dual lock off valves

Exhaust

  • Exhaust outlet with 3” pipe

Generator

  • Permanent magnet excitation
  • Full load capacity alternator
  • Class H insulation material
  • Permanent magnet excitation
  • Integrated Voltage Regulator
  • Matched to the performance and output characteristics of Cat engines
  • Class H insulation material
  • Full load capacity alternator
  • IP23 Protection

Controls

  • EMCP 4.2 Series generator set controller

Mounting

  • Vibration isolaton (puck type)
  • Rubber vibration isolators

Electric Power - Package Serial Number Prefix

  • Battery charging alternator

Electric Starting and/or Prelube

  • Battery cables
  • Solenoid activated starter motor
  • Engine electrical system
  • Solenoid activated starter motor

Governor

  • Electronic governor (non adjustable)

Control Panel

  • EMCP 4.2 Series generator set controller

Starting/Charging

  • Batteries with rack and cables
  • 12 volt starting motor
Optional Equipment

Starting/Charging

  • Jacket water heater
  • Battery heater
  • Charging alternator
  • Battery charger – UL Listed 10 amp

General

  • Enclosures: sound attenuated, weather protective
  • Suitable for Use as Service Equipment (SUSE)
  • Automatic transfer switches (ATS)
  • UL 2200 package
  • CSA Certification

Generator

  • Thermal magnetic or electronic trip MCCBs
  • Anti-condensation heater
  • Shunt trip and auxiliary contact breaker
  • Anti-condensation heater
  • Excitation: [ ] Permanent Magnet Excited (PM)
  • Oversize and premium generators