G16CM34 Gas Engine

G16CM34 Gas Engine

The G16CM34 is a natural gas, spark ignited, V-style, turbocharged and aftercooled engine that provides: low emissions, high efficiency, high reliability, high flexibility, constant torque and variable speed. ...
PDF Print SHARE

Engine Specifications

Minimum Rating
8180HP
Maximum Rating
8180HP
Emissions
U.S. EPA SI NSPS Site Compliant Capable

Stroke

Stroke
420mm

Rotation from Flywheel End

Rotation from Flywheel End
Counterclockwise

Oil Change Interval

Oil Change Interval
7500 hrs

Governor and Protection

Governor and Protection
Electronic (ADEM™ A3)

Flywheel Teeth

Flywheel Teeth
408

Displacement

Displacement
610 L (37,209 in3)

Compression Ratio

Compression Ratio
11.4:1

Bore

Bore
340mm

Aspiration

Aspiration
Turbocharged-2 Stage Aftercooled

Weight - Dry

Weight - Dry
82000kg

Engine Design

- Tough and durable, built on industry standard G3300 platform - Caterpillar supplied air/fuel ratio control and threeway catalyst designed specifically for this engine to provide superior emissions control with NSPS and NonAttainment zone compliance- 0.5 g and 1 g NOx settings available - Integrated operator interface panel, TWC and AFRC reduces hands-on time with the engine - Operator interface panel allows setup and servicing without a laptop- Runs on a broad range of fuels and speeds at any emissions level- Factory installed components with single connection point eases packaging

Full Range of Attachments

Large variety of factory-installed engine attachments reduces packaging time

PRODUCT SUPPORT OFFERED THROUGH GLOBAL CAT DEALER

More than 2,200 dealer outletsCat factory-trained dealer technicians service every aspect of your petroleum engineCaterpillar parts and labor warranty. Preventive maintenance agreements available for repairbefore-failure optionsS•O•SSM program matches your oil and coolant samples against Catepillar set standards to determine:- Internal engine component condition- Presence of unwanted fluids- Presence of combustion by-products- Site-specific oil change interval

OVER 80 YEARS OF ENGINE MANUFACTURING EXPERIENCE

Over 60 years of natural gas engine productionOwnership of these manufacturing processes enables Caterpillar to produce high quality, dependable products.- Cast engine blocks, heads, cylinder liners, and flywheel housings- Machine critical components- Assemble complete engine

Standard Equipment:

Optional Equipment:

    Air Inlet System
    • Inlet air Pre-heater – required for inlet air temperature below -20°C (-4°F)
    Exhaust Gas System
    • Exhaust Ventilation System – purge the entire exhaust gas system to maintain gas concentration below ignition point reducing the risk of exhaust gas explosion. The skid is certified for Class 1, Division 2, Group D hazardous location
    General
    • Bearing Temperature Monitor – to monitor temperature of the main crankshaft bearings and the connecting rod big end bearings.     Engine Special Tools – set of special tools for GCM34 engines.